上海网站公安备案号百度在线识别图片

1、功能
Si5340/41-D可以输出任意频率，当然有范围，100Hz_{1GHz。外部输入为24M或者48}54M的XTAL，VCO在13500~14256Mhz之间，控制接口采用IIC或者SPI。
芯片架构图

2、IIC控制方式


3、直接上控制代码
使用米联客ZU3EG，将控制接口接入到PS的IIC上

4、控制需要注意的寄存器
输出公式
P0=IN*(M_NUM/M_DEN)/R_REG/(N_NUM/N_DEN)
(1)输入选择

(2)输出配置


(3)Divider

(4)分数倍频器 M_NUM/M_DEN

(5)第一级整数分频器R_REG

(6)分数分频器N_NUM/N_DEN

5、PS控制
（1）写函数

int si5340_write(XIicPs *I2C_Ptr,u16 register_address, u8 data) {u8 slave = SI5340_SLAVE_ID;u8 page_byte;page_byte = (register_address >> 8);int status;u8 page_select_send_buff[2] = {0x01,page_byte};status = XIicPs_MasterSendPolled(I2C_Ptr, page_select_send_buff, 2, slave);u8 reg_byte;reg_byte = (register_address & 0xFF);u8 write_reg_send_buff[2] = {reg_byte,data};status = XIicPs_MasterSendPolled(I2C_Ptr, write_reg_send_buff, 2, slave);return status;
}

（2）读函数

u8 si5340_read(XIicPs *I2C_Ptr,u16 register_address) {u8 slave = SI5340_SLAVE_ID;u8 page_byte;page_byte = (register_address >> 8);u8 page_select_send_buff[2] = {0x01,page_byte};XIicPs_MasterSendPolled(I2C_Ptr, page_select_send_buff, 2, slave);u8 reg_byte;reg_byte = (register_address & 0xFF);XIicPs_MasterSendPolled(I2C_Ptr, &reg_byte, 1, slave);u8 data;XIicPs_MasterRecvPolled(I2C_Ptr, &data, 1, slave);return data;
}

6、控制结束
控制函数在链接
https://download.csdn.net/download/sinat_39724439/88525099