第1篇:Arduino与ESP32开发板的安装方法

第2篇:ESP32 helloword第一个程序示范点亮板载LED

1.下载vscode并安装

https://code.visualstudio.com/

运行VSCodeUserSetup-x64-1.80.1.exe 

2.点击扩展，搜索arduino,并点击安装

 3.点击扩展设置，配置arduinoIDE安装路径

根据arduino.exe的安装目录进行配置

 

4.输入Chinese,安装中文语言包 

 

 5.安装其余插件

6.创建项目目录

D:\Arduino_Project\esp32_dev 

 

 

 D:\Arduino_Project\esp32_dev目录下创建blink2.txt 把txt后缀改为blink2.ino

 

 7.用vsocde打开文件夹

 

关闭提示Arduino CLI提示

 

 7.打开ino，拷贝blink 点亮led的测试程序

/*BlinkTurns an LED on for one second, then off for one second, repeatedly.Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZEROit is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set tothe correct LED pin independent of which board is used.If you want to know what pin the on-board LED is connected to on your Arduinomodel, check the Technical Specs of your board at:https://www.arduino.cc/en/Main/Productsmodified 8 May 2014by Scott Fitzgeraldmodified 2 Sep 2016by Arturo Guadalupimodified 8 Sep 2016by Colby NewmanThis example code is in the public domain.https://www.arduino.cc/en/Tutorial/BuiltInExamples/Blink
*/// the setup function runs once when you press reset or power the board
//esp32 dev module#define led 2
void setup() {// initialize digital pin LED_BUILTIN as an output.Serial.begin(115200);pinMode(led, OUTPUT);
}// the loop function runs over and over again forever
void loop() {digitalWrite(led, HIGH);   // turn the LED on (HIGH is the voltage level)delay(1000); Serial.println("led is high");                      // wait for a seconddigitalWrite(led, LOW);    // turn the LED off by making the voltage LOWdelay(1000);    Serial.println("led is low");                    // wait for a second
}

 8.选择开发板

 

9.配置端口 

 

 

 10.开始编译

 

[Warning] Output path is not specified. Unable to reuse previously compiled files. Build will be slower. See README.

 

11.上传程序